Magneta Trailers - RRT60 FROM ETRAILERS

This versatile trailer improves on the roof rack by taking it off of the roof and putting it on wheels, enhancing convenience and increasing your hauling capacity. The simple design of this sturdy steel trailer also makes it an economical option.

Features:

• Trailer includes (2) 60" long load bars - just like a roof rack but on a trailer
  • 80" Long load bars are available (LB80; sold separately)
• Easier to use than a roof rack - eliminates the back strain associated with lifting your gear overhead
• Greater hauling capacity than either roof racks or hitch-mounted cargo carriers
• Simple design helps to make this trailer a low-cost option
• Versatile and customizable - haul anything that you can put on a roof rack
  • Carry canoes, kayaks, bikes, surfboards, snowboards, skis, storage pods and cargo baskets in any combination to meet your gear-hauling needs
• Heavy-duty construction
  • Tubular steel frame with galvanized finish
  • High-speed axle Maximum speed: 55 mph
  • Heavy-duty leaf springs
• Submersible marine lights - back right up to the water without damaging your lights
  • 4-Pole flat wiring system with connector included
• Trailer tongue can be partially detached then slid into the frame to decrease required storage space
• Storage stand (VTS1; sold separately) stows trailer vertically to minimize required storage space
• Assembly required
  • Includes all hardware and wiring
  • Assemble using basic hand tools
• Licensing paperwork included
• Made in the USA

Specs:

• Standard tongue carries boats up to 14' long
  • Tongue extenders (sold separately) accommodate longer boats
    • 2' Extender (RRTX2) - 16' boat
    • 4' Extender (RRTX4) - 18' boat
    • 6' Extender (RRTX6) - 20' boat
• Payload capacity with included load bars: 600 lbs
• Overall dimensions: 60" wide x 132" long
• Frame construction: 2" x 3" and 2" x 2" tubular steel
• Weight: 250 lbs
• Tire/wheel size: 4.80-12
  • Maximum speed: 55 mph
• Coupler:
  • Ball size: 2"
  • Measurement from bottom of coupler to the ground when trailer is level: 16"
• Load bars:
  • Dimensions: 60" long x 2" wide x 1" tall
  • Height above the ground: 26"
  • Spread (center to center): 34"
  • Eye bolts set 1-1/2" from ends of load bars
    • 56" Between eye bolts along the length of each bar
• 1-Year warranty

Unlike hitch-mounted carriers and typical roof racks, this high-capacity "roof rack on wheels" isn't limited by how much cargo weight your roof or side rails can support or by the tongue weight capacity of your trailer hitch, so don't worry about overloading. Its effective payload is 600 pounds, yet it weighs just 250 pounds. The high-speed axle, tubular steel construction and tough galvanized finish make for a durable, heavy-duty sport trailer.

The low loading height of this gear hauler helps you to avoid the strain of lifting your canoes, kayaks, bikes and other large and heavy equipment over your head to a roof rack, making it easy to transport all your stuff.

The towable roof rack meets just about any gear-hauling challenge you can find. Add carriers from your favorite companies, like SportRack, Thule and Yakima. You can even combine accessories to carry all your different types of equipment at one time - for example, bicycles and kayaks, kayaks and canoes, or bicycles and storage pods, to name just a few possibilities.

The trailer comes with two 60-inch-long load bars, and there is 56 inches of space between the two tie-downs on each load bar. Eighty-inch load bars are also available (LB80; sold separately) to provide even more space. Or you can swap out the included load bars with your bars from Thule or Yakima, which require different U-bolts (SPTH01 for Thule and SPYA01 for Yakima; sold separately) for installation on the trailer.

 

 

The standard tongue can accommodate a boat up to 14 feet long. Tongue extenders (sold separately) come in 2-foot, 4-foot and 6-foot lengths, each allowing the trailer to carry 2 feet more of boat length. The 6-foot tongue extender will accommodate a 20-foot-long boat.

 

 

To reduce the amount of storage space needed, the U-bolts that attach the tongue can be loosened, allowing it to slide into the trailer's frame. A storage stand (VTS1; sold separately) holds the trailer vertically to decrease the storage space requirement even more. Stored dimensions with the stand are 5 feet wide x 3 feet deep x 8-1/2 feet tall.